Benutze ein Tp-Link WD8980B mit Lede und mir werden folgende Werte angezeigt:

Firmware Version:                         5.7.9.9.0.6
API Version:                              4.17.18.6
XTSE Capabilities:                        0x0, 0x0, 0x0, 0x0, 0x0, 0x0, 0x0, 0x2
Annex:                                    B
Line Mode:                                G.993.2 (VDSL2)
Profile:                                  17a
Line State:                               UP [0x801: showtime_tc_sync]
Forward Error Correction Seconds (FECS):  Near: 0 / Far: 624
Errored seconds (ES):                     Near: 0 / Far: 4
Severely Errored Seconds (SES):           Near: 0 / Far: 1
Loss of Signal Seconds (LOSS):            Near: 0 / Far: 0
Unavailable Seconds (UAS):                Near: 35 / Far: 35
Header Error Code Errors (HEC):           Near: 0 / Far: 0
Non Pre-emtive CRC errors (CRC_P):        Near: 0 / Far: 0
Pre-emtive CRC errors (CRCP_P):           Near: 0 / Far: 0
Power Management Mode:                    L0 - Synchronized
Latency / Interleave Delay:               Down: Fast (0.16 ms) / Up: Interleave (9.0 ms)
Data Rate:                                Down: 18.458 Mb/s / Up: 1.463 Mb/s
Line Attenuation (LATN):                  Down: 3.5dB / Up: 1.0dB
Signal Attenuation (SATN):                Down: 3.5dB / Up: 1.0dB
Noise Margin (SNR):                       Down: 6.9dB / Up: 9.3dB
Aggregate Transmit Power (ACTATP):        Down: 13.6dB / Up: -2.6dB
Max. Attainable Data Rate (ATTNDR):       Down: 19.987 Mb/s / Up: 1.485 Mb/s
Line Uptime Seconds:                      1376
Line Uptime:                              22m 56s

Wenn ich jetzt nichts falsch verstehe ist die Noise Margin relativ hoch oder nicht?